EV-SC598-EZKIT

This project contains a comprehensive BSP for the EV-SC598-EZKIT SoM plus carrier board ez-kit.

For full details about this project, features and set up instructions, please refer to: https://wiki.analog.com/resources/tools-software/sharc-audio-module/advanced-audio-projects

• Install CCES as-per Analog Devices instructions (3.0.2 CCES Version Minimum Required!)
• Install Git bash shell from here: https://git-scm.com/downloads
• Instead of Git bash, one can also install MinGW/MSYS2 from here: http://www.msys2.org/

• Check your path first to see if it already includes the desired version of CCES. In general Git bash inherits the path and MinGW/MSYS2 does not unless it's launched with '-use-full-path' option.

echo $PATH  # Check inherited path

• If necessary, modify the 'env.sh' shell to match your CCES installation directory and include the environment in your shell.

. ./env.sh # Note the space between the first two periods!

• Go into the build directory and type make

cd build
make      # Add -j4 for a faster build on multi-core machines

• Open CCES, create a new debug configuration
• Load build/ezkitSC598W_preload_core0 into core0
• Also load the EV-SC598-EZKIT-ARM.exe executable into core0
• Load EV-SC598-EZKIT-SHARC0.dxe into core1
• Load EV-SC598-EZKIT-SHARC1.dxe into core2
• In the Automatic Breakpoints tab, uncheck Enable Semihosting
• Save and start debugging.

• Follow below steps for Rev-D or earlier SoM
  • Download ADI Serial Flash Programmer: https://www.analog.com/en/resources/evaluation-hardware-and-software/embedded-development-software/crosscore-utilities.html.
  • Plug in the USB-C from PC to the connector on the SOM.
  • Select ADSP-SC598-SOM as target.
  • Set the blue rotary switch on the ez-kit to position 3 and reset the board
  • Program the board using the serial flash programmer
  • Set the blue rotary switch back to one and reset the board
  • Additional details/instructions can be found in the Wiki
• Follow below steps for Rev-E SoM through ICE-2000
  • Set the rotary switch on the SoM to position zero and reset the board
  • Program the board using cldp by running flash_RevE_SoM.bat . ./flash_RevE_SoM.bat
  • Set the blue rotary switch back to one and reset the board