An Alternate Method For Creating Cleavage
Crossdressers often like to
wear low-cut dresses and want to show a little or a lot of
cleavage. There are several ways to create cleavage.
A company on the web sells a special bra-like item
that will create cleavage. Another way is to use tape
pulled across the chest. For many, this has been expensive
and/or painful. I have used the tape method in the past.
I have found it to be uncomfortable, and marks are left on
the chest after removal.
A third way is described below and can be made by cutting
out a piece of plastic from a wastebasket, the top of a storage
bin, or any item of flexible plastic of appropriate size.
Cut out and sand edges smooth.
I have experimented with sizes
and shapes and have found the two following to be most beneficial.
The size of the green one is 9"w X 5"h X 1/16"
and the blue one is 11"w X 5"h X 1/16".
A slightly snug bra and breast
forms help to keep the plastic in place, but with a lot of
movement the skin will eventually let the plastic move and
the cleavage will 
disappear.
A few pieces of Transpore tape will help keep it in
place. But be careful not to place the tape where it
will adhere to the breast form.
I have found that spraying multi-purpose
spray adhesive on the inside of the plastic keeps it in place.
Be sure to let the craft glue dry for 10 to 15 minutes before
inserting. This coating will last for several wearings
One of my sisters uses an almost
identical item, except she has covered it with adhesive tape
and coated that with rubber cement to make it slightly tacky.
This helps prevent it from slipping. I have tried spraying
the inside of the plastic with adhesive and found it very
effective. Be sure to let the adhesive dry 5-10 minutes
to a tacky consistency for a temporary bond.
To finish the illusion use some
dark powder where the breast meets the chest.
Using this insert
is inexpensive and much more comfortable than tape.
Some other sites for Cleavage..
.
Classic
curves
The
Breast Form Store
Cindy's
Oasis reprint
Home
TGToday
